Wrangler 4WD L4-150 2.5L VIN P MFI (1998)
corrected.
With the exception of the warning lamp trouble codes or malfunctions, when a malfunction is detected, the AIRBAG lamp remains lit for a minimum of
12 seconds or as long as the malfunction is present.
Stored Codes
Airbag codes are automatically stored in the ACM's memory when the ignition is turned off with the exception of the Loss of Ignition Run Only code,
which is an active code only.
A "stored" code indicates there was an active code present at some time. However, the code currently may not be present as an active code, although
another active code could be.
When a trouble code occurs, the AIRBAG warning lamp illuminates for 12 seconds minimum (even if the problem existed for less than 12 seconds). The
code is stored, along with the time in minutes it was active, and the number of times the ignition has been cycled since the problem was last detected.
The minimum time shown for any code will be one minute, even if the code was actually present for less than one minute. Thus, the time shown for a
code that was present for two minutes 13 seconds, for example, would be three minutes.
If a malfunction is not active while performing a diagnostic test procedure, the active code diagnostic test will not locate the source of the problem. In
this case, the stored code can indicate an area to inspect.
If no obvious problems are found, erase stored codes, and with the ignition "on," wiggle the wire harness and connectors, rotate the steering wheel from
stop to stop. Recheck for codes periodically as you work through the system. This procedure may uncover a malfunction that is difficult to locate.
Airbag Trouble Codes
The airbag control module may report any of the following diagnostic trouble codes.
For the following active or stored codes, replace the airbag control module (ACM) even if set intermittently:
-
AECM Accelerometer
-
AECM Output Driver
-
AECM Stored Energy Logic
-
AECM Stored Energy Driver
-
AECM Stored Energy Passenger
-
Internal Diagnostic 1
-
Internal Diagnostic 2
-
Internal Diagnostic 3
-
Internal Diagnostic 4
-
Safing Sensor Shorted
For these codes, refer to the appropriate diagnostic procedure:
-
Driver Squib Circuit Open
-
Passenger Squib Circuit Shorted
-
Driver Squib Circuit Shorted
-
Passenger Squib Circuit Shorted
-
Loss of Ignition Run Only
-
Either Squib Term Shorted to Battery
-
Loss of Ignition to Run/Start
-
Either Squib Term Shorted to Battery
-
No Cluster CCD Bus Message
-
Warning Lamp Circuit Open/Shorted
-
No CCD Communication
