Wrangler 4WD L4-150 2.5L VIN P MFI (1998)
Powertrain Control Module: Description and Operation
(A/C) Controls-PCM Input
AIR CONDITIONING (A/C) CONTROLS-PCM INPUT
The A/C control system information applies to factory installed air conditioning units.
A/C SELECT SIGNAL: when the A/C switch is in the ON position, an input signal is sent to the powertrain control module (PCM). The signal
informs the
PCM that the A/C has been selected. The PCM adjusts idle speed to a pre-programmed rpm through the idle air control (IAC) motor to compensate
for increased engine load.
A/C REQUEST SIGNAL: Once A/C has been selected, the powertrain control module (PCM) receives the A/C request signal from the evaporator
switch. The input indicates that the evaporator temperature is in the proper range for A/C application. The PCM uses this input to cycle the A/C
compressor clutch (through the A/C relay). It will also determine the correct engine idle speed through the idle air control (IAC) motor position.
If the A/C low-pressure switch opens (indicating a low refrigerant level), the PCM will not receive an A/C receive signal. The PCM will then remove
the ground from the A/C relay. This will deactivate the A/C compressor clutch.
If the evaporator switch opens, (indicating that evaporator is not in proper temperature range), the PCM will not receive the A/C request signal. The
PCM will then remove the ground from the A/C relay, deactivating the A/C compressor clutch.
