Wrangler 4WD L4-150 2.5L VIN P MFI (1998)
19.
Tighten exhaust manifold to exhaust pipe nuts to 35 ft. lbs. (48 N.m).
20.
Install the exhaust pipe to muffler clamp and tighten the clamp nuts to 35 ft. lbs. (48 N.m).
21.
Install the rear oxygen sensor and tighten to 35 ft. lbs. (48 N.m).
22.
Connect the rear oxygen sensor to the wiring harness.
23.
Install the front oxygen sensor and tighten to 35 ft. lbs. (48 N.m).
24.
Connect the front oxygen sensor to the wiring harness.
25.
Position the skid plate such that the transmission isolator mounting studs are properly located and install the skid plate bolts. Tighten the bolts to
50 ft. lbs. (68 N.m).
26.
Install and tighten the nuts fastening the transmission isolator mount to the skid plate. Tighten to 30 ft. lbs. (41 N.m).
27.
Connect the battery and continue with Section D - Install the Authorized Modification Label.
NOTE:
If the catalyst replacement is due to the illumination of the MIL with DTC P0420 present, disconnect the negative battery cable and wait at least 60
seconds. This will clear all DTC(s) stored. An Authorized Modification Label for this Recall E22 should have already been affixed. Reconnect the
battery cable and return the vehicle to the owner. To enhance customer satisfaction, remember to set the clock.
D. Install the Authorized Modifications Label
1.
Type or print (with a ballpoint pen) the recall number, dealer code and date on the Authorized Modifications Label (Figure 5).
2.
Attach the label near the VECI label and close the hood.
E. Complete Proof of Correction Form For California Residents
This recall is subject to the State of California Registration Renewal/Emissions Recall Enforcement Program. Complete a Vehicle Emission Recall Proof
of Correction Form (Form No. 81-016-1053) and supply it to vehicle owners residing in the state of California for proof that this recall has been
performed when they renew the vehicle registration.
