Wrangler 4WD L4-150 2.5L VIN P MFI (1998)
Fuel Pressure Regulator: Service and Repair
FUEL FILTER/FUEL PRESSURE REGULATOR
The combination Fuel Filter/Fuel Pressure Regulator is located on the fuel pump module. The fuel pump module is located on top of fuel tank.
The filter/regulator may be removed without removing fuel pump module although fuel tank must be removed.
REMOVAL
1
Remove fuel tank. Refer to Fuel Tank Removal/Installation.
2
Clean area around filter/regulator.
Fig. 11 Fuel Filter/Fuel Pressure Regulator
3
Remove retainer clamp from top of filter/regulator (Fig. 11). Clamp snaps to tabs on pump module. Discard old clamp.
4
Pry filter/regulator from top of pump module with 2 screwdrivers. Unit is snapped into module.
Fig. 12 Fuel Filter/Fuel Pressure Regulator Gasket
5
Discard gasket below filter/regulator (Fig. 12).
