Wrangler 4WD L4-150 2.5L VIN P MFI (1998)
Fig. 13 Fuel Filter/Fuel Pressure Regulator 0-Rings
6
Discard 0-rings on bottom of filter/regulator (Fig. 13). If the smallest of the two o-rings can not be found on bottom of filter/regulator, it may be
necessary to remove it from the fuel inlet passage in fuel pump module.
INSTALLATION
1
Install new 0-rings to grooves on filter/regulator. Apply a small amount of clean engine oil to o-rings.Do not install 0-rings separately into fuel
pump module. They will be damaged when installing filter/regulator.
2
Install new gasket to top of fuel pump module.
3
Press filter/regulator into top of pump module until it snaps into position (a positive click must be heard or felt).
4
The arrow (Fig. 11) on top of fuel pump module should be pointed towards front of vehicle (12 o'clock position).
5
Rotate filter/regulator until fuel supply tube (fitting) is pointed to 10 o'clock position.
6
Install new retainer clamp (snaps) to top of filter/regulator.
7
Install fuel tank. Refer to Fuel Tank Removal/Installation.