Wrangler 4WD L4-150 2.5L VIN P MFI (1998)
Crankshaft Position Sensor: Service and Repair
With Automatic Transmission
Crankshaft Position Sensor
The crankshaft position sensor is mounted to the transmission bellhousing at the left/rear side of the engine block.
The sensor is attached with two nuts.
REMOVAL
1. Near rear of intake manifold, disconnect pigtail harness (electrical connector) from main electrical harness.
2. Depending upon application, remove either sensor mounting bolt(s) or nuts.
3. Remove sensor from engine.
INSTALLATION
1. Install and tighten two sensor mounting nuts to 19N.m(14 ft. lbs.) torque.
