Wrangler 4WD L4-150 2.5L VIN P MFI (1998)
Body Control Module: Scan Tool Testing and Procedures
DRB III Error Messages and Blank Screen
Using the DRB
Refer to the DRB user's guide for instructions and assistance with reading trouble codes, erasing trouble codes, and other DRB functions.
DRB
DRBIII Error Messages and Blank Screen
Under normal operation, the DRB will display one of only two error messages:
- User-Requested WARM Boot or User-Requested COLD Boot
If the DRB should display any other error message, record the entire display and call the MDS Hotline,
or call for information and assistance at 1-800-825-8737. This is a sample of such an error message
display:
-
ver: 2.14
-
date: 26 Jul93
-
file: key-iff.cc
-
date: Jul 26 1993
-
line: 548
-
err:0x1
User-Requested COLD boot
Press more to switch between this display
and the application screen.
Press F4 when done noting information.
DRBIII Does Not Power Up
If the LED's do not light or no sound is emitted at start up, check for loose cable connections or a bad cable. Check the vehicle battery voltage (data link
connector cavity 16). A minimum of 11 volts is required to adequately power the DRB.
If all connections are proper between the DRB and the vehicle or other devices, and the vehicle battery is fully charged, an inoperative DRB may be the
result of faulty cable or vehicle wiring. Perform Vehicle Communication TEST 1A
Display is Not Visible
Low temperatures will affect the visibility of the display. Adjust the contrast to compensate for this condition.
DRBIII Safety Information
DRBIII Safety Information
