Wrangler 4WD L4-150 2.5L VIN P MFI (1998)
3.
Install the console to the transmission tunnel. Refer to the Full Floor Console or Mini Floor Console in the removal and installation section of
group 23 - Body for procedures.
4.
Reach through the glove box opening to engage the passenger side airbag on/oft wire harness in the retaining bracket that supports the heater A/C
housing.
5.
Reaching through the glove box opening, access and reconnect the two passenger side airbag on/off switch wires harness connector to the
instrument panel wire harness. These connectors are retained on a bracket located on the heater A/C housing. Be certain that both connectors are
full engaged In the latch.
6.
Install the glove box into the instrument panel. Refer to the Glove box on the Removal and Installation section of group 8E - Instrument Panel
Systems for the procedures.
7.
Do not reconnect the battery negative cable at this time. Refer to the Airbag System in the Diagnosis and testing section of the service manual for
the proper procedures.
