Wrangler 4WD L4-150 2.5L VIN P MFI (1998)
Coolant Temperature Sensor/Switch (For Computer): Testing and Inspection
ENGINE COOLANT TEMPERATURE SENSOR
To perform a complete test of the engine coolant temperature sensor and its circuitry, refer to Powertrain Management/Computers and Control
Systems/Testing and Inspection.
See: Powertrain Management/Computers and Control Systems/Testing and Inspection
To test the sensor only, refer to the following:
Engine Coolant Temperature Sensor
1. Disconnect wire harness connector from coolant temperature sensor (Fig. 30).
Sensor Resistance (Ohms)-coolant Temperature Sensor/Intake Air Temperature Sensor
2. Test the resistance of the sensor with a high input impedance (digital) volt-ohmmeter. The resistance (as measured across the sensor terminals)
should be as shown in the Coolant Temperature Sensor/Intake Air Temperature Sensor resistance chart. Replace the sensor if it is not within the
range of resistance specified in the chart.
3. Test continuity of the wire harness between the PCM wire harness connector and the coolant sensor connector terminals. Refer to
Diagrams/Electrical for terminal/cavity locations. Repair the wire harness if an open circuit is indicated.
