Wrangler 4WD L4-150 2.5L VIN P MFI (1998)
Fuse Block: Service and Repair
REMOVAL
WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO AIRBAGS BEFORE ATTEMPTING ANY STEERING WHEEL,
STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. FAILURE TO TAKE THE PROPER
PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.
1. Disconnect and isolate the battery negative cable.
2. Remove the glove box from the instrument panel. See Glove Box for the procedures.
Fuseblock Module Remove/Install
3. Reach through the glove box opening and remove the two screws that secure the fuseblock module to the bracket on the dash panel.
4. Remove the fuseblock module from the dash panel.
5. Reverse the removal procedures to install. Tighten the mounting screws to 3.3 N.m (30 in. lbs.).
