Wrangler 4WD L4-150 2.5L VIN P MFI (1998)
Neutral Safety Switch: Service and Repair
Clutch Switch Bypass
CLUTCH INTERLOCK SAFETY SWITCH BY-PASS
WARNING: This procedure is intended for use only off-road. When the vehicle is returned to road use, properly connect the clutch
interlock safety switch. Dangerous conditions may result.
The Clutch Interlock Safety Switch will inhibit the starter cranking circuit until the clutch pedal is depressed. In some off-road situations this safety
feature is not desirable.
Clutch Interlock Safety Switch By-Pass
BY-PASS PROCEDURE
1. Disengage wire connector from clutch interlock safety switch, located under the instrument panel next to the 100-way connector.
2. Locate open by-pass connector, located next to the 100-way connector.
3. Engage clutch interlock switch harness connector into by-pass connector.
Reverse the preceding procedure to activate the Clutch Interlock Safety Switch.
