Wrangler 4WD L4-150 2.5L VIN P MFI (1998)
9. Install gasket to side cover and bend tabs around edges of side cover.
10. Install pitman shaft assembly and side cover to housing.
11. Install side cover bolts and tighten to 60 Nm (44 ft. lbs.).
12. Adjust Over-Center Rotation Torque.
Housing End Plug Replacement
DISASSEMBLY
1. Unseat and remove retaining ring from groove with a punch through the hole in the end of the housing.
2. Rotate stub shaft slowly COUNTER-CLOCKWISE to force the end plug out from housing.
CAUTION: Do not turn stub shaft any further than necessary. The rack piston balls will drop out of the rack piston circuit if the stub shaft is
turned too far.
3. Remove O-ring from the housing.
ASSEMBLY
1. Lubricate O-ring with power steering fluid and install into the housing.
2. Install end plug by tapping the plug lightly with a plastic mallet into the housing.
