Wrangler 4WD L4-150 2.5L VIN P MFI (1998)
Band: Adjustments
FRONT BAND ADJUSTMENT
The front (kickdown) band adjusting screw is located on the left side of the transmission case above the manual valve and throttle valve levers.
1. Raise vehicle.
Front Band Adjustment Screw Location
2. Loosen band adjusting screw locknut. Then back locknut off 3-5 turns. Be sure adjusting screw turns freely in case. Apply lubricant to screw
threads if necessary.
3. Tighten band adjusting screw to 8 Nm (72 inch lbs.) torque with Inch Pound Torque Wrench C-3380-A, a 3-inch extension and 5/16 socket.
Band Adjustment Adapter Tool
CAUTION: If Adapter C-3705 is needed to reach the adjusting screw, tighten the screw to only 5 Nm (47-50 inch lbs.) torque.
4. Back off front band adjusting screw 2-1/2 turns for the 30RH and 2-1/4 turns for the 32RH.
5. Hold adjuster screw in position and tighten locknut to 41 Nm (30 ft. lbs.) torque.
6. Lower vehicle. ;bal
REAR BAND ADJUSTMENT
The transmission oil pan must be removed for access to the rear band adjusting screw.
1. Raise vehicle.
2. Remove transmission oil pan and drain fluid.
3. Loosen band adjusting screw locknut 5-6 turns. Be sure adjusting screw turns freely in lever.
