Wrangler 4WD L4-150 2.5L VIN P MFI (1998)
Governor Body
12. Remove bolts holding governor body to park gear.
13. Separate governor from park gear.
14. Pull park gear from rear support.
INSTALLATION
1. Install park gear into rear support so crown on curved boss is in line with hole through output shaft.
2. Install governor filter in park gear.
3. Slip governor body over output shaft and align port to filter.
Governor Body
4. Install bolts to hold governor body to park gear. Tighten bolts to 11 Nm (95 inch lbs.) torque.
5. Install governor body-park gear snap rings and washer on output shaft as follows:
Snap Rings And Spacer
a. Install thin snap ring first. Then install thrust washer second, and thick snap ring last.
