Wrangler 4WD L4-150 2.5L VIN P MFI (1998)
Tightening Pinion Shaft Nut-Typical
5. If the rotating torque is low, use Holder 6958 to hold the pinion yoke, and tighten the pinion shaft nut in 6.8 Nm (5 ft. lbs.) increments until proper
rotating torque is achieved.
CAUTION: If the maximum tightening torque is reached prior to reaching the required rotating torque, the collapsible spacer may have been
damaged. Replace the collapsible spacer.
6. Align the installation reference marks on the propeller shaft and yoke and install the propeller shaft.
7. Check and fill the gear lubricant.
8. Install the brake rotors and calipers.
9. Install wheel and tire assemblies.
10. Lower the vehicle.
