Wrangler 4WD L4-150 2.5L VIN P MFI (1998)
Rear Properller Shaft
6. Slide the slip yoke off of the transmission/transfer case output shaft and remove the propeller shaft.
INSTALLATION
Rear Properller Shaft
1. Slide the slip yoke on the transmission/transfer case output shaft. Align the installation reference marks at the axle yoke and install the propeller
shaft.
2. Tighten the U-joint strap/clamp bolts at the axle yoke to 19 Nm (14 ft. lbs.) torque.
Crimping Dust Boot Clamp
3. Crimp clamp to hold dust boot to propeller shaft yoke.
4. Lower the vehicle.
