Wrangler 4WD L4-150 2.5L VIN P MFI (1998)
7. Flip assembly and repeat Step 4, Step 5, and Step 6 to remove the opposite bearing cap. This will then allow removal of the cross centering kit
assembly and spring.
8. Press the remaining bearing caps out the other end of the link yoke as described above to complete the disassembly.
ASSEMBLY
During assembly, ensure that the alignment marks on the link yoke and propeller shaft yoke are aligned.
1. Apply extreme pressure (EP) N.L.G.I. Grade 1 or 2 grease to inside of yoke bores to aid in installation.
Install Cross In Yoke
2. Fit a cross into the propeller shaft yoke.
Install Bearing Cap
3. Place a bearing cap over the trunnion and align the cap with the yoke bore. Keep the needle bearings upright in the bearing assembly. A needle
bearing lying at the bottom of the cap will prevent proper assembly.
