Wrangler 4WD L4-150 2.5L VIN P MFI (1998)
Universal Joint: Description and Operation
PROPELLER SHAFT JOINTS
Single Cardan U-Joint
Double Cardan U-Joint
Two different types of propeller shaft joints are used in TJ vehicles. None of the joints are serviceable. If worn or damaged, they must be replaced as a
complete assembly.
PROPELLER SHAFT JOINT ANGLE
When two shafts come together at a common joint, the bend that is formed is called the operating angle. The larger the angle, the larger the amount of
angular acceleration and deceleration of the joint. This speeding up and slowing down of the joint must be cancelled to produce a smooth power flow.
This is done through the phasing of a propeller shaft and ensuring that the proper propeller shaft joint working angles are maintained.
A propeller shaft is properly phased when the yoke ends are in the same plane, or in line. A twisted shaft will make the yokes out of phase and cause a
noticeable vibration.
When taking propeller shaft joint angle measurements, or checking the phasing, of two piece shafts, consider each shaft separately.
Ideally the driveline system should have;
-
Angles that are equal or opposite within 1 degree of each other.
-
Have a 3 degree maximum operating angle.
-
Have at least a V2 degree continuous operating (propeller shaft) angle.
