Wrangler 4WD L4-150 2.5L VIN P MFI (1998)
Seals and Gaskets: Service and Repair
Axle Shaft Seal and Bearing
REMOVAL
1. Remove axle shaft from vehicle.
Drill Retaining Ring
2. Using a 3/8 inch dia. drill bit, drill a shallow hole into soft steel axle bearing retaining ring. If possible, use a drill depth stop to avoid marking
axle.
Cut Retaining Ring
3. Using a suitable cold chisel, cut retaining ring across drilled hole.
4. Slide retaining ring from axle shaft.
