Wrangler 4WD L4-150 2.5L VIN P MFI (1998)
Axle Bearing And Seal Remove
5. Using Splitter 1130 placed between the seal and bearing and a suitable Arbor Press, press unit bearing from axle shaft.
6. Slide seal from axle.
7. Slide retaining plate from axle shaft.
INSTALLATION
1. Using a suitable straight edge, verify flatness of axle shaft retaining plate. Replace plate if warped.
Axle Bearing And Seal Components
2. Install retaining plate on axle.
3. Apply a coat of multi-purpose grease on sealing surface of axle seal.
4. Install seal on axle with cavity away from retaining plate.
5. Lubricate bearing with MOPAR Wheel Bearing Grease, or equivalent. Wipe excess grease from outside of bearing.
6. Slide bearing onto axle shaft with groove in outer surface toward seal.