Wrangler 4WD L4-150 2.5L VIN P MFI (1998)
Windshield Washer Spray Nozzle: Service and Repair
REMOVAL
Front
1. Open and support the hood.
Front Washer Nozzles Remove/Install
2. From under the rear of the hood, disconnect the washer supply hose from the barbed nipple of the washer nozzle.
3. From under the rear of the hood, gently squeeze the nozzle retainers and push the nozzle out through the top of the hood panel.
4. Reverse the removal procedures to install. See Washer Nozzles and Plumbing for the nozzle adjustment procedures.
Rear
1. Disconnect and isolate the battery negative cable.
Rear Washer Nozzle Remove/Install
2. From the inside of the liftglass, remove the three screws that secure the rear wiper motor cover to the motor.
3. Remove the rear wiper motor cover.
4. Disconnect the washer supply hose from the barbed rear washer nozzle nipple.
5. While holding the nozzle securely from the outside of the liftglass, remove the plastic nut that secures the threaded nozzle nipple from the inside of
the liftglass.
6. Push the nozzle and seal out through the liftglass from the inside.
7. Reverse the removal procedures to install. Tighten the washer nozzle nut to 0.9 N.m (8 in. lbs.).
