Wrangler 4WD L4-150 2.5L VIN P MFI (1998)
Fig.11 Rear Wiper Arm Installation
3. Install the rear wiper arm with the wiper motor in the Park position. Place the rear wiper blade on the lift-glass so that it is parallel to or tipped
down from the upper edge of the lift-glass a maximum of 8O mm (3.14 in.).
4. Lift the wiper arm away from the lift-glass slightly to relieve the spring tension on the latch. Push the latch into the locked position and slowly
release the arm until the wiper blade rests on the lift-glass.
5. Operate the wiper with the lift-glass wet, then turn the wiper switch to the Off position. Check for the correct wiper arm positioning and readjust if
required.
