Wrangler 4WD V6-3.8L (2009)
Door/Trunk Ajar Indicator/Lamp: Description and Operation
Door Ajar Warning Indicator - Operation
OPERATION
The ajar indicators give an indication to the vehicle operator that one or more of the passenger compartment doors or the swing gate may be open or not
completely latched. These indicators are controlled by the instrument cluster logic circuit based upon cluster programming and electronic ajar switch
status messages received by the cluster from the Totally Integrated Power Module (TIPM) over the Controller Area Network (CAN) data bus.
The ajar indicator function of the odometer Vacuum-Fluorescent Display (VFD) unit is completely controlled by the instrument cluster logic circuit, and
that logic will only allow this indicator to operate when the instrument cluster receives a battery current input on the fused B(+) circuit. Therefore, the
VFD ajar indications can occur regardless of the ignition switch position. The instrument cluster will turn ON the ajar indicator for the following
reasons:
-
Ajar Switch Message Input - Each time the cluster receives a door or swing gate ajar switch status message indicating that a door, the swing gate
or any combination of these is open or not completely latched with the ignition switch in any position, the appropriate ajar textual message will be
illuminated. If the cluster detects a vehicle speed input greater than zero (kilometers or miles-per-hour) while the ignition switch is in the ON or
START positions, the ajar indication will be accompanied by a single chime tone. When the ignition switch is in any position except ON or
START, any and all ajar indications will time out after about five minutes.
The TIPM continually monitors the door and swing gate ajar switches to determine the status of the doors and swing gate. The TIPM then sends the
proper ajar switch status messages to the ElectroMechanical Instrument Cluster (EMIC) (also known as the Cab Compartment Node/CCN). The door
and swing gate ajar switches and their circuits may be diagnosed using conventional diagnostic tools and methods. Refer to the appropriate wiring
information.
