Wrangler 4WD V6-3.8L (2009)
Parking Light Bulb: Service and Repair
Park/Turn Signal Bulb - Removal
BULB
1. Disconnect and isolate the battery negative cable.
2. Reach behind the lower outboard corner of the grille panel (1) to access and disconnect the wire harness connector from the bulb socket connector
receptacle (3) on the back of the park/turn signal lamp (2).
3. Firmly grasp the bulb socket on the back of the lamp housing and rotate it counterclockwise about 30 degrees to unlock it.
4. Pull the socket and bulb straight out from the keyed opening in the housing.
5. Pull the base of the bulb straight out of the socket.
