Wrangler 4WD V6-3.8L (2009)
Wheel Bearing: Service and Repair
Front Hub and Bearing - Installation
INSTALLATION
1. Install the hub bearing to the knuckle.
2. Install the hub bearing to knuckle and the 3 bolts (3) then tighten to 102 Nm (75 ft. lbs.).
3. Install the axle nut if equipped. Tighten to 136 Nm (100 ft. lbs.).
4. Install the wheel speed sensor (1) through the hole in the brake shield (2)See: Brakes and Traction Control/Antilock Brakes / Traction Control
Systems/Wheel Speed Sensor/Service and Repair/Wheel Speed Sensor - Installation/Front.
