Amanti V6-3.5L (2006)
6. If any of the following conditions is met, replay is prohibited and operation will stop if it is in replay.
When the ignition is OFF.
When the" P" position switch is OFF (when the shift lever is at the position other than " P" ) When the vehicle speed is over 3 km/h (when it last
more than 2 or 3 seconds).
When the manual switch in relation to the seat is in operation. (Seat related replay operation stops)
When the stop switch is ON.
7. Control in reverse operation.
When the motor is driven reverse during the operation, it performs reverse operation after 60 ± 10 ms and 100 ± 10 ms from completing the
current operation in slide, reclining and front/rear height respectively.
8. Determining operational priority.
In order to prevent overlapping of rushing current when the motor starts up, motor start-up is delayed for 100 ± 10 ms respectively and its
operational priority is as follows.
Slide > Reclining > Front height > Rear height
9. Sequential timer settings for motor start-up.
Slide : 20 ± 2 seconds (in memory replay)
Reclining : 35 ± 3 seconds (in memory replay)
Front/Rear height: 10 ± 1 seconds
Slide, Reclining: It operates depending on the switch input time in manual switch input (direct drive type)
REGISTRATION AND REPLAY BY THE KEYLESS
1. Keyless registration operation
1. Ignition ON and OFF positions are registered corresponding to the keyless codes.
2. Keyless codes are determined by the keyless door lock operation.
2. Keyless replay operation
1. Upon door unlock operation when the ignition is OFF, it automatically set the registered positions corresponding to the keyless code.
However, seat slide is automatically set to the following positions.
2. If any of the following conditions is met, keyless replay operation is prohibited and operation stops if it is in operation.
-
When the P position switch is OFF
-
When the switch is in manual operation
-
When the stop switch is ON
BUZZER OUTPUT
1. In case of memory permit status (memory switch is ON): once
2. When memory registration is complete (position switch is ON): twice
3. When the memory replay is in operation (position switch is ON): once
4. When error is detected due to the sensor failure: 10 times
