Amanti V6-3.5L (2006)
2. Control in memory replay
1. View range setting
View range should satisfy the following criteria considering the structure of the mirror.
-
Horizontal direction: 1.5 - 3.5 V
-
Vertical direction: 1.5 - 3.5 V
Specifically speaking, view range here indicates the following
-
Mirror control range not limited by the mechanical lock in the unit itself.
-
Mirror control range not affecting the sensor characteristics (sensing linearity)
2. Determination of driving path
Since mirror can be mechanically locked due to the structure outside the view range, it is wise to set the driving path while driving the mirror
to prevent those mechanical locks.
3. Detection of the lock
-
Motor driving time is monitored using the timer to detect the lock.
-
Monitoring of the replay execution time If the replay operation does not complete within the 40 seconds after the start of the replay
control, then stop the motor output and terminates the control.
3. Outside mirror auto-reverse function
1. When the" Ft" of the shift lever is changed from 0 to 1, pull down the outside mirror for 5 degrees by the position of mirror selection switch.
2. When the " R" is changed from 1 to 0, it returns to the registered position (previous position before " R" is changed to 1 from 0)
3. When the mirror selection switch is in L: Left and right outside mirror all moves together.
4. When the mirror selection switch is in R: only the right outside mirror moves.
5. When the mirror selection switch is in neutral: Nothing moves.
6. Manual switch input during the mirror down operation. It stops the current operation and operates only by the manual switch, and returns to the
registered position when " R" is changed to 0 from 1.
7. Mirror switch input during the mirror down operation: It stops the current operation and returns to the registered position when " R" is changed
to 0 from 1.
8. Manual switch input during the returning operation: It stops the returning operation and operates by the switch input.
9. Position switch input during the returning operation: It completes the returning operation if it is re-play-prohibiting condition, otherwise it
performs the replay operation.
10. If the stop switch is inputted during the operation, it stops the operation and returns to the previously registered position when " R" is changed
to 0 from 1. It stops returning if it is in returning operation.
11. Auto-reverse prohibiting operation
-
When the ignition OFF
-
When the auto switch is OFF
-
When the stop switch is ON
-
When the manual switch is ON
