Amanti V6-3.5L (2006)
Memory Positioning Systems: Description and Operation
IMS Mirror Control
IMS MIRROR CONTROL
DESCRIPTION
Optimal mirror position setting can be registered in the mirror control unit by IMS control switch and mirror position sensor by the driver. (This is so
called registration operation No.1). Therefore, registered position can be replayed by one touch even after the mirror position has been changed. (This is
replay operation No.1). In addition, the keyless can restore the original mirror position that it used be when the driver left the vehicle. (Only if the mirror
position has been changed). (This is called replay operation No.2). Above mentioned function can accommodate 2 drivers in maximum.
System Composition
SYSTEM COMPOSITION
FUNCTION
MIRROR POSITION CONTROL
Mirror position sensor reads each mirror motor displacement all the time. Mirror position is registered by the registration command through the IMS
switch operation Likewise, mirror position replay is performed by the replay command through the IMS switch operation. As shown in the system
component diagram, manual control of mirror position is performed by the input from the mirror switch, which has the priority over registration and
replay control
MOTOR DRIVE CONTROL
1. Driving sequence
In principle, driving sequence is from horizontal direction to vertical direction As for the displacement in one direction while the mirror is driving
in the other direction, hysteresis of target value 0.06 V is set.
