Amanti V6-3.5L (2006)
of HCU and connect TMC tubes to HCU.
f.
Remove pedal support.
g. Remove fluid reservoir cap and fill reservoir to "MAX" with new DOT 4 brake fluid.
h. Lift vehicle or use inspection pit.
3.2 Bleeding conventional brake system See section 1.2 3.3 Vehicle disconnection according to 1.3
4. Brake bleeding after caliper replacement.
4.1 Vehicle preparation
a. Connect bleeder bottle tube to bleed screw of FL and RL caliper and open them.
b. Actuate the brake pedal (>60 mm (2.36 inch)) and secure if by using a pedal support. This closes the TMC central valves and prevents
fluid flowing out of the opened brake system.
c. Close FL and RL caliper bleeder screws and remove bleeder bottle.
d. Replace defective caliper with a new one.
e. Remove fluid reservoir cap and fill reservoir to "MAX" with new DOT 4 brake fluid.
4.2 Bleed procedure
Only the new caliper has to be bled according to the conventional bleeding method. (see section 1.2)
4.3 Vehicle disconnection according to 1.3
5. Brake fluid renewal
5.1 Vehicle preparation
a. Connect bleeder unit to brake fluid reservoir. Fill pressure maximum 3 bar.
b. Lift vehicle
5.2 Bleed procedure
a. Connect bleeder bottle tube to FL caliper bleed screw and open it.
b. Leave screw open until new, clear, bubble-free fluid is observed in tube.
c. Close bleed screw.
d. Repeat above procedure for the remaining wheel calipers.
5.3 Vehicle disconnection
a.
Remove the bleeder unit.
b.
Act according to 1.3
