Amanti V6-3.5L (2006)
1. Install the intake manifold with new gasket and tighten nuts in order as shown figure.
Tightening torque: 19.6 - 22.6 Nm (2.0 - 2.3 kg-m, 14.5 - 16.6 ft. lbs.)
2. Install the water pump bracket.
Tightening torque: 19.6 - 26.5 Nm (2.0 - 2.7 kg-m, 14.5 - 19.5 ft. lbs.)
3. Install the timing belt covers.
Tightening torque: 9.8 - 11.8 Nm (1.0 - 1.2 kg-m, 7.2 - 8.7 ft. lbs.)
4. Install the delivery pipe and injector assembly.
Tightening torque: 9.8 - 12.7 Nm (1.0 - 1.3 kg-m, 7.2 - 9.4 ft. lbs.)
5. Install the surge tank assembly.
Tightening torque: 14.7 - 19.6 Nm (1.5 - 2.0 kg-m, 10.8 - 14.5 ft. lbs.)
6. Install the EGR valve hose, the EGR valve mounting bolts, the EGR pipe fixing bracket bolt and the surge tank stay mounting bolts.
Tightening torque:
Surge tank stay: 14.7 - 19.6 Nm (1.5 - 2.0 kg-m, 10.8 - 14.5 ft. lbs.)
EGR pipe bracket: 14.7 - 19.6 Nm (1.5 - 2.0 kg-m, 10.8 - 14.5 ft. lbs.)
EGR valve: 16.7 - 25.5 Nm (1.7 - 2.6 kg-m, 12.3 - 18.8 ft. lbs.)
7. Install the bracket of the injector harness connector, the crank angle sensor connector and the cam angle sensor connector.
8. Reconnect the vacuum hoses between the cylinder head cover and the intake manifold. Reconnect the fuel pressure regulator vacuum hose, the
purge control solenoid valve hose and the throttle body heater hose.
9. Reconnect the throttle position sensor connector, the Electronic Throttle System (ETS) motor connector, the limp-home connector and the purge
solenoid valve connector.
10. Reconnect the crank angle sensor connector, the cam angle sensor connector, the injector harness connector, the power steering switch connector,
the variable intake motor connector (2ea), the accelerator position sensor connector, the EGR solenoid connector and the injector connector.
11. Install the air cleaner assembly (bolt 3ea).
Tightening torque: 7.8 - 9.8 Nm (0.8 - 1.0 kg-m, 5.8 - 7.2 ft. lbs.)
12. Reconnect the air flow sensor connector and the vacuum hose to the air intake hose. And then clamp the hose with the air hose clamp.
13. Reconnect the battery terminal.
14. Install the engine cover.
