Amanti V6-3.5L (2006)
2. Lamp failure condition
When one of the front or rear is broken-down (Lamp failure), the turn signal blinks with double frequency The double blinking works at IGN2 ON
condition, double blinking for Hazard Except side lamp, if any error condition is detected then triggered the double blinking.
Period: More than 120 Cycle/min
STOP LAMP FAILURE CONTROL
The purpose of this function is to indicate stop lamp(s) failure and brake fuse failure Depending on foot brake pedal switch input, brake fuse and lamp
failure is detected In IGN1 ON State, when stop lamp fuse is failed (stop lamp failed = ON) or when a stop lamp failure is detected (stop lamp fuse failed
= ON), then indicator lamp output is turned ON.
When Brake pedal is pedaled, the stop lamp failure is detected. The stop lamp failure is confirmed after a delay of 200 ms. When the failure disappears
the present failure is cleared thanks to the fault manager.
BUZZER AND TIMER CONTROL
BUZZER CONTROL
SOUND PRIORITY
-
1 st: Diagnostic sound (provided to test the Buzzer by way of Diagnostic tool)
-
2nd : Seatbelt warning
-
3th : Key operated warning
-
4th : Key learning sound (Learning with diagnostic tool)
1. SEAT BELT WARNING TIMER
1. Seat belt warning lamp and warning sound stop at IGN1 OFF during the operation. With a seat belt SW on, warning sound stops immediately
but seat belt warning indicator continues working for the remained time.
2. Warning lamp and warning sound are always activated for one period if seat belt is released after seatbelt was fastened during IGN1 ON status.
3. If IGN1 is turned OFF during seat belt warning, the seat belt warning indicator and buzzer stops immediately.
