Amanti V6-3.5L (2006)
OUTSIDE MIRROR CONTROL BY THE SWITCH
1. Manual control of left outside mirror
If the mirror direction switch (up, down, left and right) is pressed when mirror selection switch on driver side power window switch is in outside
LH under ACC ON condition, then mirror motor moves to the corresponding direction.
2. Manual control of right outside mirror
If the mirror direction switch (up, down, left and right) is pressed when mirror selection switch on driver side power window switch is in outside
RH under ACC ON condition, then operating signal is sent to passenger side power window switch through CAN communication
OUTSIDE MIRROR MEMORY OPERATION BY THE MEMORY SWITCH
1. If position switch (POS1 or POS2) is pressed within 5 seconds after pressing the memory switch under ignition 2 on, it registers current mirror
position. (Switch module sends in LIN communication). (Memory permit status lasts for 5 seconds after memory switch ON. After 5 seconds,
memory permits status terminates. In other words, current position is registered if the position switch (POS1 or POS2) is turned on, during the
memory permit status). However. RH side mirror position is not registered during the LH side mirror manual switch operation.
2. Memory permit status is released if any of the following conditions is met.
-
After 5 seconds elapse from memory switch ON.
-
When the ignition 2 is OFF
-
When the memory stop switch is ON
-
When memory registration is complete
3. If more than 2 switches are pressed simultaneously between memory switch and position switches (POS1 or POS2), input is ignored. (Switch
module sends in LIN communication)
4. Memory registration cannot be performed if the vehicle speed is over the speed limit or shift lever is not in " P" while the parking brake is
released.
5. Memory is cleared if the battery is removed.
OUTSIDE MIRROR REPLAY OPERATION BY THE MEMORY SWITCH
1. Mirror is returned to the registered position as each position switch is pressed while the ignition 2 is ON.
2. Memory replay operation will be performed only if the memory is registered.(POS1 or POS2)
3. If the position switch (POS1 or POS2) is pressed while the memory replay is in operation, the final switch is effective.
4. Replay inhibit condition
