Amanti V6-3.5L (2006)
2. In case of IGN2 = ON & HEAD LAMP = ON status, if washer switch input is detected, head lamp washer output is turned ON.
RAIN SENSING WIPER (FOR CANADA ONLY)
In IGN2 ON state, if auto SW input (UN communication) is ON then both wiper low relay and wiper high relay outputs are controlled by the rain sensor
input signal 1 When the wiper switch is moved to auto position and the Ignition switch is in IGN2 position, the Rain sensor is considered to be in
"automatic" mode
1. If the wiper switch has been left in automatic mode with the vehicle ignition OFF, and then the vehicle ignition switch is turned on, a single wipe
will be performed.
2. A single wipe will be performed whenever rain has been detected(Rain Detected signal from Rain sensor) and the wiper switch is moved to the
AUTO position. But a single wipe will not be performed when the wiper switch is moved to the AUTO position and OFF signal is being received
from Rain sensor But if the wiper switch is moved to AUTO position for the first time since vehicle ignition switch is turned on then a single wipe
will be performed regardless of rain detected or OFF signal.
