Amanti V6-3.5L (2006)
1.
Connect the power supply cable to the GDS tool.
*NOTICE
If attempting to perform the ECU upgrade with the power supply cable disconnected from the GDS tool, be sure to check that the GDS tool is fully
charged before ECU upgrade. If the GDS tool is not fully charged, failure to perform the ECU upgrade may occur. Therefore, it is strongly
recommended that the power supply connector be connected to the GDS tool.
2.
Connect the USB cable between the VCI and the GDS tool
*NOTICE
When performing the ECU upgrade using the GDS tool, wireless communication between the VCI and GDS tool is not available. Therefore, be sure
to connect the USB cable between the VCI and the GDS tool.
3.
Connect the Main 16-pin DLC cable (GHDM - 241000) to the VCI, and then attach the 10-pin adaptor (GHDM - 248000) to the end of the Main
DLC cable.
4.
Plug the 10-pin adapter (GHDM - 248000) into the white colored 10-pin connector located behind the upper side panel on the driver's side of the
dash.
5.
With the ignition key ON, turn on the VCI and GDS tool. Access the GDS tool's vehicle identification number (VIN) screen and configure the
vehicle by manually entering the last 6 digits of the VIN.
*NOTICE
Auto VIN detection is not possible through the 10-pin connector located on the driver's side of the dash. When using this connector to perform an
Auto Mode upgrade, you must first manually configure the VIN, otherwise Auto Mode upgrade will fail.
6.
Once back at the GDS Main Screen, select ECU upgrade from the bottom right-hand corner.
Next select Auto Mode, Engine. Perform the ECU upgrade in accordance with normal GDS tool ECU upgrade procedures.
Manual Mode ECU Upgrade Passwords
7.
When the GDS tool reports that the ECU upgrade has been successfully completed, click OK, turn OFF the ignition key, and wait at least 20
seconds before attempting to start the engine.
WARRANTY CLAIM INFORMATION:
