Amanti V6-3.5L (2006)
13. Remove the O-ring from the connector.
CAUTION: Do not disassemble the flow control valve.
14. Remove the oil pump switch.
15. Take out the spring and the spool.
16. Remove the O-ring from the oil pump switch.
INSPECTION
1. Clean all disassembled parts with a suitable cleaning solvent.
2. If any inside parts of the oil pump have been damaged, replace the pump as an assembly.
3. If the pulley is cracked or deformed, replace it.
4. If oil leaks around the pulley shaft oil seal, replace the oil seal.
5. If the serrations of the pulley or pulley shaft are deformed or worn out, replace them.
REASSEMBLY
1. Install the oil pump switch.
2. Install the flow control valve spring, valve and connector in the pump body.
NOTE: Apply a thin coat of power steering fluid to all parts including the oil seal and O-ring.
3. Install the guide bracket and nut.
4. Using special tool (09222-32100), install the oil seal into the pump body.
5. Gently insert the shaft assembly and install the snap ring.
