Amanti V6-3.5L (2006)
17. With the pinion turned all the way clockwise, tighten the self-locking nut.
CAUTION: Always replace the self-locking nut with a new one.
18. Apply semi-drying sealant to the threaded section of the end plug and tighten to the specified torque.
Tightening torque 49 - 68.6 Nm (5 - 7 kg-m, 36.2 - 50.6 ft. lbs.)
19. Stake the end plug at two points on its circumference with a punch.
20. Install the tab washer and then the tie rod and hammer the tab washer end at two points to the tie rod.
CAUTION:
^
Align the tab washer pawls with the rack grooves.
^
Use a new tab washer.
21. Install the bushing, rack support, yoke support spring and rack plug in the order shown. Apply semi-drying sealant to the threaded section of the
yoke plug support cover before installation.
22. With the rack placed at the center position, attach the yoke plug to the gear housing. Tighten the yoke plug within the range of 19.6 - 24.5 Nm (2.0
- 2.5 kg-m,14.5 - 18.1 ft. lbs.), using the special tool. Loosen the yoke plug for approximately 20° and tighten the locking nut to the standard
valve.
Standard valve
Total pinion torque: 49 - 68.6 Nm (5 - 7 kg-m, 38.2 - 50.6 ft. lbs.)
23. After adjusting, install the yoke plug with lock nut.
NOTE: When it cannot be adjusted within the specified return angle, check rack support plug components or replace.
