Amanti V6-3.5L (2006)
24. Tighten the feed tube to the,specified torque and install the mounting rubber with adhesive.
25. Apply the specified grease to the bellows mounting position (fitting groove) of the tie rod.
Recommended grease
Multipurpose grease SAE J310a, NLGI No.2
26. Install the new attaching band to the bellows.
CAUTION: Whenever the bellows are installed, a new band must be used
27. Install the bellows in, taking care not to twist it.
28. Fill the dust cover inner side and lip with the specified multipurpose grease, and place the dust cover in position with the clip ring attached in the
groove of the tie rod end.
Recommended grease
Multipurpose grease SAE J31 Oa, NLGI No.2
29. Install the tie rods so that the length of the left and right tie rods equals the standard value.
(A) Tie rod free length: 60.2 ± 1 mm
INSTALLATION
1. When installing the mounting rubber, align the projection of the mounting rubber with the indentation in the cross member to install the gear box.
2. Confirm that there is no oil leak.
3. Confirm that the steering wheel rotates smoothly when it is turned.
