Amanti V6-3.5L (2006)
Shifter A/T: Testing and Inspection
SHIFT LEVER
INSPECTION
1. Adjusting method for control cable.
1. Connect "P" shift lock cable according to adjusting procedure for "P" shift lock cable.
2. As shown in fig. 1 set room side lever and T/M side lever to N position.
3. Connect the end part of ATM cable to at lever.
4. Connect T/M side lever to cable in following orders.
1. Push cable at the transmission side slightly and cable must have no free play.
2. Tighten nut with specified torque.
5. After adjusting according to (2)-(4), check to be sure that this part operates surely at each range of T/M side corresponding to each position of
room lever.
2. Installation procedure of lock cam and check item
1. Move A/T lever to "P" position to set key lock cam and shift lock cam as shown Fig.2.
1. Check that key lock cam is located at "B" by detent pin.
2. Check that shift lock cam is located at "A".
3. Adjusting procedure for "P" shift lock cable
1. Check that each lock cam is shown in fig.2.
2. Install shift lock cable in position according to this drawing. In this case, shift lock cable must be fixed to brake pedal in position.
3. Temporarily install shiftlock cable to A/T lever assy as shown in Fig. 3. Securely insert cable end into fixing point of shift lock cam.
4. Doing the work of (3), slightly pull outer casing of shift lock cable to direction "E" to stretch cable. In this case, shift lock cam must not move.
5. After checking portion of cable end touches cable fixing pin of shift lock cam. Fix outer casing with nut.
6. Check the installation condition of the shift lock cam as shown Fig. 4.
4. Adjusting and install procedure for key inter lock cable
1. Install key inter lock cable in position according to this drawing.
2. After assembling C/PAD module and inserting the key into the lock cylinder insert the lock cylinder into the lock body through the C/PAD key
hole with "ACC" condition.
