Amanti V6-3.5L (2006)
7. Pierce the sealant with a pull knife and cut all the way around the windshield from outside the vehicle.
8. Remove the glass to a safe place.
INSTALLATION
1. Remove the excess sealant from the glass with a window scraper.
2. Remove the excess sealant and foam dam from the body with a knife.
3. Clean the inside of the glass with commercial glass cleaner and a lint-free cloth.
4. Prime an area approximately 20 mm(3/4 inch) wide around the complete perimeter of the glass.
5. Prime the contact area on the body.
6. Reprime the same area on the inside surface of the glass.
CAUTION: Do not permit any primed surface to become contaminated with dirt, water, oil, etc. Do not touch primed surfaces with your hands.
Contamination will affect adhesion.
7. Install the self-adhesive foam dam to the body where the original dam had been.
