Amanti V6-3.8L (2007)
Side Air Bag: Service and Repair
Curtain Air Bag
AIR BAG MODULE (CURTAIN AIR BAG)
REMOVAL
CAUTION:
-
Never attempt to disassemble or repair the airbag module.
-
Do not drop the airbag module or allow contact with water, grease or oil Replace it if a dent, crack, deformation or rust is detected.
-
The airbag module should be stored on a flat surface and placed so that the pad surface is facing upward. Do not place anything on top of
it.
-
Do not expose the airbag module to temperature over 93 °C (200 °F).
-
An undeployed airbag module should only be disposed in accordance with the procedures.
-
Never attempt to measure the circuit resistance of the airbag module (squib) even if you are using the specified tester. If the circuit
resistance is measured with a tester accidental airbag deployment will result in serious personal injury.
-
Whenever the CAB is deployed it should be replaced with a new one assembled with an extension wire. The squib is melt down if the CAB
is deployed making the extension wire useless.
1. Disconnect the negative (-) cable from battery and wait for at least three minutes.
2. Remove ignition key from the vehicle.
3. Remove the headliner.
4. Disconnect the CAB connector from the inflator. At this time release the connector locking clip.
5. Unscrew the CAB mounting bolts (A) and remove the Curtain Airbag (CAB) module from the vehicle.
INSTALLATION
CAUTION: Be sure to install the harness wires so that they are not pinched or interfering with other parts.
