Amanti V6-3.8L (2007)
CAUTION
The valve nut should not be re-used.
2. Discard the valve assembly.
INSTALLATION
SENSOR FIT
CAUTION
^
Handle the sensor with care.
^
Avoid lubricant contact if possible.
1. Assemble valve to sensor and turn valve 3 times with the square part of the screw in the slot.
CAUTION
^
The fit should not be tight i.e. it should still be possible to easily adjust valve angle.
^
Ensure that the wheel to be fitted is designed for sensor mount. There should normally be a mark to indicate this.
^
Ensure that the valve hole and mating face of the wheel are clean.
2. Mount assembly to wheel.
CAUTION
Ensure sensor feet are against the wheel throughout the remainder of the assembly process.
3. Tighten washer and nut by hand until the valve thread meets the nut built-in calibrated stop.
CAUTION
Ensure that the grommet remains in contact with the wheel.
