Borrego 2WD V6-3.8L (2009)
Console Lamp: Service and Repair
Overhead Console Lamp
Removal
1. Disconnect the negative (-) battery terminal.
2. Remove the mounting 2 screws.
And then remove the overhead console (A).
3. Remove the overhead console lamp (B) from the head lining after disconnecting the sunroof switch connector and map lamp switch connector (A).
4. If the bulb only should be replaced, replace the bulb after removing the lens.
Installation
1. Install the overhead console lamp after connecting the sunroof switch connector and lamp connector.
2. Install the lens after tightening 2 screws.
