Borrego 2WD V6-3.8L (2009)
2. Manual Control for O/S Mirror RH
A. At the ACC or RUN ON state, if the mirror select switch in the SW ASSY P/WDW MAIN is the RH state and the mirror direction switches
(UP, DOWN, LEFT, and RIGHT) are operated, then the driving signal shall be sent to the SW ASSY P/WDW MAIN through the CAN.
Memory Operation By Memory Switch
1. If the position switch (POS1 or POS2) within 5 seconds after the memory switch ('SET' SW) is pushed at the ON state of the IGN2 (the switch
module shall send the state signal through can), the present mirror position shall be memorized. (The 5-second duration from the ON state of the
memory switch is the memory allowance period so that the allowance state shall be released if the 5 second duration is passed. That is, if the
position switch (POS1 or POS2) is ON during the memory allowance period, and then the present position shall be memorized.) Except, when the
mirror manual switch at the LH is operated, the mirror position at RH shall not be memorized.
2. Inhibiting and releasing of saving mode may be carried out when any of following conditions is satisfied:
A. - If 5 seconds is elapsed after the memory switch is turned on
B. - If the ignition 2 is turned off
C. - When saving is completed
D. - If "Ignition Sw Sts" of the CAN communication data sent by the IPM is not "Run"
E. - If "Inhibit Sw Sts" of the CAN communication data sent by the CLU is not "P"
F. - If "Vehicle Speed" of the CAN communication data sent by the CLU is over "3Km/h
3. If the battery is removed, the memory must be cleared. (only position data)
Reminder Operation By Memory Switch
1. When the each position switch is pressed at the ON state of the IGN2 or B+ (drive door open or for 30 seconds after drive door close), the mirror
shall be positioned according to the memorized value.
2. If the position switch (POS1 or POS2) has not been memorized, then the reminding operation shall not be performed.
3. During reminding operation, if a position switch (POS1 or POS2) is pressed and then the latest pressed switch shall govern the reminding
operation.
4. Prohibit Condition for the Reminding Operation
A. When the mirror manual switch is being operated.
B. If "Ignition Sw Sts" of the CAN communication data sent by the IPM is not "Run"
(On condition of ACC is "off", be able to remind during drive door open or for 30 seconds after drive door close)
C. If "Inhibit Sw Sts" of the CAN communication data sent by the CLU is not "P"
D. If "Vehicle Speed" of the CAN communication data sent by the CLU is over "3Km/h
Auto Reverse Function
