Borrego 2WD V6-3.8L (2009)
T2 : 0.5 ± 0.1 sec
Time Chart #2
T1 : 6 ± 1 sec
T2 : 0.5 ± 0.1 sec
Time Chart #3
T1 : 6 ± 1 sec
T2 : 0.5 ± 0.1 sec
Safety and Security
Central Lock/Unlock
Description
Central locking/unlocking logic is controlled by IPM. Locking/Unlocking inputs are located in ADM, DDM (Lock/Unlock switch, door knobs, door key
cylinder) and in IPM (RKE receiver).
Locking/Unlocking actuators are located in ADM for assist door, DDM for driver door and RAM for rear doors and tailgate.
There are 5 ways of operating central lock/unlock:
-
With Key fob
-
With Smart key ECU (when equipped)
-
With Door Lock/Unlock switches located on ADM/DDM (assist/driver door trim).
-
With Door Key Cylinder Lock/Unlock switches located on assist/driver door.
-
Treatment for those switches depends on the country.
RAM/ADM/DDM Input Control
Except for RKE, all inputs for controlling lock/unlock actions are located on ADM, DDM or RAM.
ADM/DDM/RAM controls those inputs and manages the configuration according to the country. IPM controls central lock/unlock process.
If a lock/unlock command is issued by ADM/DDM to IPM through CAN, IPM does not check the command validity according to the country.
Door Lock Monitoring Switches
Door Lock Monitoring Switches are equipped on all vehicles. ADM/DDM send Assist door Lock Monitor Switch status/Driver door lock monitor switch
status to IPM with value locked when the corresponding Door Monitoring Switch indicates a locked door and unlocked otherwise.
RAM sends rear right door Lock Monitor switch status/rear left door lock monitor switch status to IPM with "Locked" value when the right/left rear
doors are locked, otherwise with "Unlocked" value.
Concerning Tailgate Open Switch status is closed handle disabled when it is closed and locked and closed handle enabled when it is closed and unlocked
Door Key Cylinder
When Assist/Driver Door Key Cylinder request lock/unlock, ADM/DDM send assist door Key Cylinder Sw Sts/ Driver door Key Cylinder Sw Sts CAN
signal with value lock/unlock.
Door Lock Switches
When Assist/Driver Door Lock Switch request lock, ADM/DDM send Assist door lock switch status /Driver door lock switch status CAN signal with
value lock.
When Assist/Driver Door Lock Switch request unlock, ADM/DDM send Assist door lock switch status /Driver door lock switch status CAN signal with
value unlock.
ADM/DDM Actuators Control
ADM and DDM control lock/unlock motors.
DDM
LOCK/UNLOCK is performed when DDM receives Door Lock Ctrl CAN signal from IPM
