Borrego 2WD V6-3.8L (2009)
Throttle Position Sensor: Testing and Inspection
Inspection
Throttle Position Sensor (TPS)
1. Connect a scantool on the Data Link Connector (DLC).
2. Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T.
3. Turn the ignition switch OFF and disconnect the scantool from the DLC.
4. Disconnect the ETC module connector and measure the resistance between the ETC module terminals 1 and 6.
Specification :Refer to Specification Section
ETC Motor
1. Turn the ignition switch OFF.
2. Disconnect the ETC module connector.
3. Measure resistance between the ETC module terminals 2 and 3.
4. Check that the resistance is within the specification.
Specification :Refer to Specification Section
