Borrego 2WD V6-3.8L (2009)
Steering Angle Sensor: Testing and Inspection
Calibration (Setting up the zero angle)
Steering Wheel Angle Sensor of a absolute angle type (CAN type) measures the angle under the standard of the zero angle set.
Calibration must be performed as following cases.
-
Replacement of the Steering Wheel Angle Speed Sensor
-
Replacement or repair of the Steering column
-
Detection of DTC codes (C1260, C1261)
-
Replacement of the longitudinal G sensor
-
Replacement of HECU
Calibration procedure
Perform wheel alignment and stand the steering wheel in a line within ±5°error.
1. Connect the scan tool.(CAN line or OBD connector)
2. Turn ignition switch on.
3. Press calibration button of the Steering Wheel Angle Sensor.
4. HECU calibration procedure is performed.
(Calibration records, DTC codes erasure)
5. Turn ignition switch off after calibration procedure.
6. Confirm success or failure of calibration.
A. Warning lamp must not be lighted when driving test (Turning left and right).
B. The ESC system will light the ESC OFF lamp when the system detects a sensor error.
