Borrego 2WD V6-3.8L (2009)
Tire Pressure Sensor: Service and Repair
Removal
Tire Removal
1. Deflate tire & remove balance weights.
NOTE:
Sensor can be unscrewed before unseating the tire bead.
CAUTION:
-
The tire bead should be broken approx. 90° from the valve side of the wheel. The bead breaker should not be set too deep.
-
Avoid tire/tool contact with the valve on dismount.
-
Dismount should end near the valve.
Sensor Removal
CAUTION:
Handle the sensor with care.
1. Remove the valve nut.
CAUTION:
The valve nut should not be re-used.
2. Discard the valve assembly.
Installation
Sensor Fit
CAUTION:
-
Handle the sensor with care.
-
Avoid lubricant contact.
-
Ensure that the wheel to be fitted is designed for sensor mount. There should normally be a mark to indicate this.
