Borrego 2WD V6-3.8L (2009)
AFFECTED VEHICLE PRODUCTION RANGE:
2009 Borrego vehicles produced from JOB #1 to 1/15/2009 with 3.8L engine
- Service Procedure
1. Connect the power supply cable to the GDS tool.
*NOTICE
2. Connect the USB cable between the Vehicle Communications Interface (VCI) and the GDS tool.
*NOTICE
3. Connect the Main 16-pin DLC cable (GHDM - 241000) to the VCI.
4. Connect the Main 16-pin DLC cable (GHDM - 241000) to the OBD-II connector, located under the driver's side of the instrument panel.
5. With the ignition key ON, turn ON the VCI and GDS tool. Access the GDS vehicle identification number (VIN) screen and configure the vehicle
using manual VIN entry.
*NOTICE
6. At the GDS Main Screen, select ECU UPGRADE from the menu buttons located on the bottom of the screen. Next, select Auto Mode, AT.
7. Perform the TCM upgrade in accordance with normal GDS tool ECU upgrade procedures.
