Borrego 4WD V6-3.8L (2009)
4. Disconnect the connector(A) from RSE LCD monitor.
Installation
Non-sunroof type
1. Install the mounting sub bracket on the roof rail by bolts if necessary.
2. Connect the monitor connector on the RSE monitor assembly until a click sound is heard.
3. Install the RSE LCD monitor assembly on the roof rail.
4. Fix the monitor on the mounting seal by clips (2EA) and then tighten the bolts (4EA).
5. Push the RSE hole cover on the monitor assembly until a click sound is heard.
Sunroof type
1. Connect the monitor connector on the RSE monitor assembly until a click sound is heard.
2. Install the RSE LCD monitor assembly on the roof panel.
3. Fix the monitor on the sunroof bracket by clips (2EA) and then tighten the bolts (4EA).
4. Push the RSE hole cover on the monitor assembly until a click sound is heard.
