Borrego 4WD V6-3.8L (2009)
Central Door Lock/Unlock
1. If Central door lock/unlock Sw is "on", driver door lock Sw Sts message is sent to lock/unlock.
2. If Key cylinder lock switch is "on", driver door key cylinder Sw Sts message is sent to lock.
3. If Key cylinder unlock switch is "on", driver door key cylinder Sw Sts message is sent to unlock.
4. If door lock Ctrl message from IPM is "driver door lock, driver door and assist door lock, rear door, tailgate and driver door lock, lock all", door
lock actuator is locked for O.5sec.
5. If door lock Ctrl message from IPM is "driver door unlock, driver door and assist door unlock, rear door, tailgate and driver door unlock, unlock
all", or lock actuator is unlocked for O.5sec.
Crash Unlock (controlled by DDM)
1. Under the condition "IGN ON", if Crash Sensor Sts message from IPM is ON, Door UNLOCK makes output.(5 ± 0.5sec)
2. Remained action goes on irrespective of OFF signal of Crash Sensor Sts message.
3. Door Lock can't make output until IGN is OFF during or after Crash Action.
4. After Crash UNLOCK, Driver Door Key Cylinder Sw Sts and Driver Door Lock Sw Sts data are not sent to LOCK though key cylinder lock Sw
and main door lock Sw is on until IGN is "OFF".
5. Unlock action is done again after 100ms if any door is still locked after Crash UNLOCK.
6. If Crash Sensor Sts message is sent on door, unlock action will be generated until IGN is "OFF"
